2017 screenset + UC300ETH + UB1 bob

If you created a new screenset and want to share it with others then please post it here. You can talk about screens here.

2017 screenset + UC300ETH + UB1 bob

Postby IamCNC » Tue Sep 05, 2017 6:39 am

I just received my UB1 breakout board, bought the 2017 screenset, have a UC300ETH, but unfortunately the combination will only work with UCCNC version 1.2043 or later.

I did not yet test the combination. Which funtionality is already known not to be working?

Is there an expected date when a new version of UCCNC will become available?
IamCNC
 
Posts: 5
Joined: Tue Aug 29, 2017 10:50 am

Re: 2017 screenset + UC300ETH + UB1 bob

Postby ger21 » Tue Sep 05, 2017 10:43 am

For now, just put the jumper on the UB1 to 5LPT, and it should work fine.
Gerry
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
ger21
 
Posts: 2663
Joined: Sat Sep 03, 2016 2:17 am

Re: 2017 screenset + UC300ETH + UB1 bob

Postby IamCNC » Tue Sep 05, 2017 8:23 pm

I Just checked the cncroom site, and see with the jumper on 5lpt, I can only use 1 analog output. That should not be a problem, I only have one spindle to control. It is only not clear to me with the jumper on 5lpt whether the UB1 uses 1khz or 48khz frequency.

Are there any other issues known, or is this the only minor thingy and I can start to setup my test rig.
IamCNC
 
Posts: 5
Joined: Tue Aug 29, 2017 10:50 am

Re: 2017 screenset + UC300ETH + UB1 bob

Postby ger21 » Tue Sep 05, 2017 11:35 pm

There's a link to 1.2043 on the CNC Room website.

http://www.cncroom.com/downloads/setup_1.2043.zip
Gerry
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
ger21
 
Posts: 2663
Joined: Sat Sep 03, 2016 2:17 am


Return to Custom Screensets

Who is online

Users browsing this forum: No registered users and 5 guests