by serlancelot » Thu Jun 27, 2024 4:35 pm
Hello, thank you, I only have the 3-axis drivers connected to the board (with the independent sources turned off), the emergency button and the limit switches connected to the board, all of them are connected through the HDBB2, and the rest of the UC300 USB outputs do not have anything connected yet. In the image I attached, the ground is connected to the outer holes (red), those are connected to ground, on the contrary, the green ones are not connected to ground. Where do you mention putting the cable, red or green? What is the latest version of the UC300 USB firmware?
A greeting!
- Attachments
-