gills wrote:The attachment main screen.PNG is no longer available
configure plugin isn't on my main screen, plugin control is. When I click on it this is what appears:
PART 1>.........
So. I briefly set up my uc300eth for spindle/cool/analog controls. Wired directly to an optocoupler module and voltmeter and set up to mach3.
Plugin slightly different but similar to axbb-e. Both units are the 300eth chip controller.
My axis numbers and outputs will be different to yours but you know where you are with those.
1. connection.
![IMG_0A.jpg (724.6 KiB) Viewed 7442 times IMG_0A.jpg](./download/file.php?id=3944&t=1&sid=cee2a889e9bcd369924f5d7a58a68b34)
- connection.
2. My axis/spindle output numbers.
![IMG_1A.jpg (890.18 KiB) Viewed 7442 times IMG_1A.jpg](./download/file.php?id=3945&t=1&sid=cee2a889e9bcd369924f5d7a58a68b34)
- axis/spindle output numbers.
3. General Outputs. NOTE: They are set Active high. Active low setting switched my controls on by default.
![IMG_2A.jpg (893.33 KiB) Viewed 7442 times IMG_2A.jpg](./download/file.php?id=3946&t=1&sid=cee2a889e9bcd369924f5d7a58a68b34)
- General Outputs
4. Spindle settings for pwm/analog use. (3% min to restrict spin speed too low for spindle).
![IMG_3A.jpg (1.12 MiB) Viewed 7442 times IMG_3A.jpg](./download/file.php?id=3948&t=1&sid=cee2a889e9bcd369924f5d7a58a68b34)
- Spindle settings
5. Pulley set for router type.
![IMG_4A.jpg (160.44 KiB) Viewed 7442 times IMG_4A.jpg](./download/file.php?id=3947&t=1&sid=cee2a889e9bcd369924f5d7a58a68b34)
- Pulley set for router type.
6. Open 'Plugin control'. (note is 300eth).
![IMG_6A.jpg (883.34 KiB) Viewed 7442 times IMG_6A.jpg](./download/file.php?id=3949&t=1&sid=cee2a889e9bcd369924f5d7a58a68b34)
- Plugin control.
Continued in next post, Part 2>......