forum.cncdrive.com

UCCNC machine control software support forum

Skip to content

is there a RTCP function in the plans?

Here is where you can request new features or special features.
Post a reply

is there a RTCP function in the plans?

Postby Polyura » Fri Nov 26, 2021 9:56 pm

Tool tip position control... are you planning to add these great features?
Polyura
 
Posts: 5
Joined: Thu Nov 18, 2021 7:59 pm
Top

Re: is there a RTCP function in the plans?

Postby cncdrive » Fri Nov 26, 2021 10:12 pm

I don't even know what that is?
cncdrive
Site Admin
 
Posts: 4874
Joined: Tue Aug 12, 2014 11:17 pm
Top

Re: is there a RTCP function in the plans?

Postby Polyura » Sun Nov 28, 2021 12:02 pm

https://infosys.beckhoff.com/english.ph ... cp.htm&id=
Polyura
 
Posts: 5
Joined: Thu Nov 18, 2021 7:59 pm
Top

Re: is there a RTCP function in the plans?

Postby cncdrive » Sun Nov 28, 2021 2:52 pm

Hmm, no we did not plan implementing this, but looks like a good idea though. Will think about it, but I can't promise anything now.
cncdrive
Site Admin
 
Posts: 4874
Joined: Tue Aug 12, 2014 11:17 pm
Top

Re: is there a RTCP function in the plans?

Postby BKG » Mon Jul 18, 2022 9:10 pm

Any progress here ?
BKG
 
Posts: 58
Joined: Fri May 10, 2019 8:32 pm
Top

Re: is there a RTCP function in the plans?

Postby cncdrive » Tue Jul 19, 2022 12:38 pm

No, we did not make any progress on this yet sorry. :(
cncdrive
Site Admin
 
Posts: 4874
Joined: Tue Aug 12, 2014 11:17 pm
Top
Post a reply

Return to Feature Request

Who is online

Users browsing this forum: No registered users and 0 guests

Powered by phpBB® Forum Software © phpBB Group