I am having a problem with a new install, I am using 1.2113 neon screen set and a Price THC. I had the table setup using Mach 3 with no problems and wanted to change to a 400ETH. Where the problems is on the Price you can test the arc Ok, up, and down signals. When I do this I can see the signals on the diagnostic page and in the lower right (THC indicators) turn on and off as I change the switch on the Price. the arc Ok signal works as when I run a simple G-code the table will not move past the line for the Arc OK signal, if I send that signal the will complete the G-code as normal. But when I test the up and down signals the appear as switch on the screen but no movement of the Z axis happens. I do have THC enabled.
The kicker is if I switch back to Mach 3 (change firmware) the signals function as they should Z moves up and down with the switch changing the Price's output signals. So to me this is not a wiring problem.
Thanks Tom