M106 + M107?? removed from v1.2112?

If you have a question about the software please ask it here.

M106 + M107?? removed from v1.2112?

Postby Robertspark » Wed Oct 09, 2019 5:44 pm

M106 : Turns the spindle PWM on (Parameters P) The range of P is 0 to 255. This macro is used to control the FAN speed in 3D printing
M107 : Turns the spindle PWM off

Has M106 + 107 been removed from uccnc???

Any reason why, thanks?

{I was controlling a probe with it} :lol:
Robertspark
 
Posts: 1892
Joined: Sat Sep 03, 2016 4:27 pm

Re: M106 + M107?? removed from v1.2112?

Postby cncdrive » Wed Oct 09, 2019 8:03 pm

No, we did not remove it.
cncdrive
Site Admin
 
Posts: 4695
Joined: Tue Aug 12, 2014 11:17 pm

Re: M106 + M107?? removed from v1.2112?

Postby Robertspark » Thu Oct 10, 2019 1:00 am

I was updating the macro manual and saw that it was not listed on the screenset help modes or within the manual, thanks I was just checking
Robertspark
 
Posts: 1892
Joined: Sat Sep 03, 2016 4:27 pm

Re: M106 + M107?? removed from v1.2112?

Postby cncdrive » Thu Oct 10, 2019 1:32 am

I have also checked that afterwards I wrote my post and it is really missing from the help page and it is a mistake in the helpscreen.
The macros are still in the UCCNC, we did not remove them and I also verified that they are working. :)
cncdrive
Site Admin
 
Posts: 4695
Joined: Tue Aug 12, 2014 11:17 pm


Return to Ask a question from support here

Who is online

Users browsing this forum: No registered users and 20 guests

cron