Feedhold Mach3+UC100

[vitber]

when I press "Feedhold" in Mach3, the machine does not stop immediately, as in UCCNC.
Machine continues until buffer in UC100 is empty.
Is it possible to correct the Mach3-Plugin for UC100?

[cncdrive]

No, it is not possible, because mach3 does not handle it's loops well and so short loop times as it is in the UCCNC would cause lost communications, because Windows is not realtime and Mach3 runs many things on the UI thread and so it does not handle these things good enough to make the loop safely that short.

[vitber]

I understood