forum.cncdrive.com

UCCNC machine control software support forum

Skip to content

Change #var value

Post anything you want to discuss with others about the software.
Post a reply

Re: Change #var value

Postby Alberto FUL » Fri Nov 16, 2018 12:14 pm

Dan911 wrote:
Alberto FUL wrote:It seems that I cannot input negative numbers

Sorry Alberto, I had only numbers and decimal allowed, I added minus(negative), I also added Get variables to check there value, plugin is still being developed.

Dan

SetandRead_Vars.zip


Sorry to bother You but negative still not work.
Alberto
Alberto FUL
 
Posts: 39
Joined: Thu Jan 12, 2017 1:48 pm
Location: Italy
Top

Re: Change #var value

Postby Dan911 » Fri Nov 16, 2018 3:25 pm

Hmmm...No bother. Just tested and all working fine on my system. I set variables with plugin and checked in UCCNC with MDI using ?#_ method, see pic.

Capture.JPG


Possibly a cultural info problem?? Here try this...
SetandRead_Vars.zip
(6.52 KiB) Downloaded 718 times
Dan911
 
Posts: 613
Joined: Mon Oct 31, 2016 1:22 am
Location: USA
Top

Re: Change #var value

Postby Alberto FUL » Fri Nov 16, 2018 6:42 pm

Hi Dan,
there's no .dll file in this.
Alberto FUL
 
Posts: 39
Joined: Thu Jan 12, 2017 1:48 pm
Location: Italy
Top

Re: Change #var value

Postby Dan911 » Fri Nov 16, 2018 7:12 pm

Alberto FUL wrote:Hi Dan,
there's no .dll file in this.


Clicked wrong file.

SetandRead_Vars.rar.zip
(5.68 KiB) Downloaded 727 times
Dan911
 
Posts: 613
Joined: Mon Oct 31, 2016 1:22 am
Location: USA
Top
Previous
Post a reply

Return to General discussion about the UCCNC software

Who is online

Users browsing this forum: No registered users and 6 guests

Powered by phpBB® Forum Software © phpBB Group