Page 1 of 1

2017 - start into run-screen?

PostPosted: Fri Oct 27, 2017 4:47 pm
by CADdy
Hi all,

is it possible to start UCCNC (with 2017 screenset) to the run-screen? When I start UCCNC it will start to an "incomplete" settings-screen.

Thanks for infos
Peter

Re: 2017 - start into run-screen?

PostPosted: Fri Oct 27, 2017 4:58 pm
by ger21
Did you edit the screen? Either you did, or I made a mistake.

In the screen editor, navigate to the Run screen, and then save the screen from there.

UCCNC starts from whatever screen it was on when it was saved.

Re: 2017 - start into run-screen?

PostPosted: Fri Oct 27, 2017 5:15 pm
by cncdrive
When you edit the screen with the screen editor and if you save the screenset with the screen editor then the UCCNC checks through all the tab pages and saves the selected ones as selected, so the current view when saving will open up on next startups of the software.
So, as Gerry said, if you open the screen editor and navigate to the main/run tabe page and then save the screenset with the screeneditor then that will appear on software startups.

Re: 2017 - start into run-screen?

PostPosted: Sat Oct 28, 2017 11:55 am
by CADdy
Hi Balazs, Hi Gerry,

thank you very much! Now the start screen is that what I want :-)

Best wishes
Peter

Re: 2017 - start into run-screen?

PostPosted: Sat Oct 28, 2017 12:10 pm
by CADdy
Hi Gerry,

ger21 wrote:Did you edit the screen? Either you did, or I made a mistake.


You didn't make a mistake, I've edited the screen a little bit:

Screenshot - 28_11.png


I hope you're okay with that.

Many greetings
Peter