Hello all,
I'm new to UCCNC + AXBB controller but so far, loving it. I have not found anything I cannot do! However, is there any way to change the default move distances in the jog - step window. I'm finding that 0.001 is pretty useless on my router and that 1mm is often not enough. I would like to change the buttons and functionality to 0.01mm - 0.1mm - 1.0mm - 10.0mm. I have found the buttons / pictures etc but no idea where to find the macros that drive these. Cheers and thanks for your help.
Mirko
Jog Step Rate Screen
3 posts
• Page 1 of 1
Jog Step Rate Screen
by dequity11 » Sat Aug 20, 2022 1:39 am
- Attachments
-
- Screenshot 2022-08-20 113737.png (46.95 KiB) Viewed 2449 times
- dequity11
- Posts: 5
- Joined: Sat Jul 30, 2022 10:23 pm
Re: Jog Step Rate Screen
by ger21 » Sun Aug 21, 2022 2:52 am
The default buttons are hard coded and don't use macros. You can create your own macros and change the button numbers to call them.
Gerry
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
- ger21
- Posts: 2675
- Joined: Sat Sep 03, 2016 2:17 am
Re: Jog Step Rate Screen
by dequity11 » Sun Aug 21, 2022 4:36 am
H i, Understood and safe to say - thats way outside of my capabilities. Thanks for your reply in any event. Rgds, Mirko
- dequity11
- Posts: 5
- Joined: Sat Jul 30, 2022 10:23 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests