forum.cncdrive.com

I've managed to work my way around editing a screenset, having been using UCCNC for only a few days. At first I thought it was far more complicated than Mach3 (Machscreen editor) but I'm getting there, slowly.

I wanted to mimic the original Mach3 setup with the 24" touchscreen, set to portrait mode. There is a blank area at the bottom (not shown on the attached image) to allow for an on-screen keyboard.

My next challenge is to figure out how to modify and setup the tool macros for the 8 position tool-changer!

Looking good.

Very nice! Interrested in sharing it?

I could consider sharing it but I'll need to tidy it up before I do. I'm pretty new to UCCNC and some of the other pages (tabs) are somewhat messy.

I'll let you know.

Perfect! Thank you!

Any idea when you might release this Screenset to the community or forsale?

Any news on this being available?
It looks to be just what I am looking for.