Page 1 of 4
New UCCNC screenset
Posted:
Thu Sep 06, 2018 4:38 pm
by kig23
Hi,
i had an old project for Mach3 that i rebuild for UCCNC. The screenset support all UCCNC motion controllers. I have to make only the Diagnostic tab (half built) and screenset will be ready to release, if anyone is interested. Soon i'll give more details. Here is a screenshot of the Run tab.
Re: New UCCNC screenset
Posted:
Fri Sep 07, 2018 4:35 am
by robertk925
Nice! Looking forward to its release.
Re: New UCCNC screenset
Posted:
Sat Sep 08, 2018 9:57 am
by kig23
The screenset is optimised for resolution 1366x768. Here are more details of the screenset.
Re: New UCCNC screenset
Posted:
Sat Sep 08, 2018 10:46 am
by ger21
Nice work. You must have a lot of time in that.
Re: New UCCNC screenset
Posted:
Sat Sep 08, 2018 11:27 am
by kig23
Thanks Gerry. I've worked two months on this project, but the design was made. Like a wrote the project was for Mach3, but i didn't make it because of the flash support and then migrating to UCCNC, i've decided to rebuild it for UCCNC. Thanks again for your appreciation.
Re: New UCCNC screenset
Posted:
Sat Sep 08, 2018 8:58 pm
by cncdrive
Nice work. I hope you will publish it so others can benefit from your hard work.
Re: New UCCNC screenset
Posted:
Sun Sep 09, 2018 9:37 am
by kig23
Thanks Balazs.
Re: New UCCNC screenset
Posted:
Fri Sep 21, 2018 12:43 pm
by ack1
Very impressive, well done
Re: New UCCNC screenset
Posted:
Wed Sep 26, 2018 11:24 pm
by mayhem2408
Sign me up. It looks great.
Re: New UCCNC screenset
Posted:
Thu Sep 27, 2018 8:23 pm
by Nema91
Great Job!
Looks really nice:)
Greetings