Page 1 of 1

Some works with 4th axis.

PostPosted: Wed Oct 05, 2016 8:29 am
by Ivan Ionov
https://www.youtube.com/watch?v=MLaJCFJQopE
I've generated several 3axis toolpath with Vectric Vcarve, and then combined them into one NC file as a subprograms like "do subprogram 1 at angles 0, 60, 120, rotate to A90 and do subprogram 2".

Timing pulley -
https://www.youtube.com/watch?v=z8ntlwbD4GA
Large thin gear -
https://www.youtube.com/watch?v=7DbTRjk8F2Y
Both are milled with manually written NC file (some variables, run subprogram N times for every tooth... )

Re: Some works with 4th axis.

PostPosted: Fri Dec 09, 2016 8:07 pm
by camivic
Great job!!!