Page 1 of 1

My Machine now with UCCNC

PostPosted: Sun Apr 01, 2018 2:45 pm
by Mallemann
Now using UCCNC, very good first impression!

I enhanced my Hobby DIY Machine with a new Controller, Based on the UC300ETH Board on the UB1 Motherboard.

For Details on the Machine check out http://www.masdrive.ch/myprojects/?page_id=381

The New Controller here: http://www.masdrive.ch/myprojects/?page_id=502

some UCCNC Impressions from a Part milling with a spiral morph strategy (forces all 3 Axes to move Simultan)
http://www.masdrive.ch/myprojects/?attachment_id=561
http://www.masdrive.ch/myprojects/?attachment_id=560