programming dg4s

If you have a question about the software please ask it here.

programming dg4s

Postby paul mcgee » Thu Jan 04, 2018 9:10 pm

struggling to progamme dg4s with programming stick, sevo configerator3 conected to the first servo driver and i was able to down load pid settings, but it does not see the other sevo drivers when i try to conect and tune those, if i revert bact to the first servo driver it still conects to this, can you sugest were i am going wrong, thanks
paul mcgee
 
Posts: 9
Joined: Thu Jan 04, 2018 8:53 pm

Re: programming dg4s

Postby paul mcgee » Fri Jan 05, 2018 9:11 am

realise what that the problem is now,
paul mcgee
 
Posts: 9
Joined: Thu Jan 04, 2018 8:53 pm


Return to Ask a question from support here

Who is online

Users browsing this forum: No registered users and 2 guests