Strange behavior

If you have a question about the software please ask it here.

Strange behavior

Postby markcadcam » Sun Nov 05, 2017 3:23 pm

I have a UC300 and a 5LPT board, Version 1.2037 software. When I went to run my mill this morning it would Home out ok and the Jog was ok. When I would enter info into the MDI window nothing happens, acts like it's locked up until I press the Reset button, no movement. If I load a program, it won't run. Again, acts like it's locked up until I Reset it, no movement. If I press GOTO ZERO nothing happens, again acts like it's locked up. The is no movement, If I run the Default program settings it works fine. I'm not sure where to look for the problem? I changed nothing from when I ran it last.
markcadcam
 
Posts: 35
Joined: Thu Apr 13, 2017 1:52 pm

Re: Strange behavior

Postby markcadcam » Sun Nov 05, 2017 4:17 pm

My bad. I had the Feedrate Over Ride set to Zero. Duh.
markcadcam
 
Posts: 35
Joined: Thu Apr 13, 2017 1:52 pm

Re: Strange behavior

Postby Robertspark » Sun Nov 05, 2017 7:25 pm

Lol ROFL
Nice!

I needed that
Rob

Einstein ― “If you can't explain it to a six year old, you don't understand it yourself”
UC400eth, UC300eth, UCCNC v1.2105, Neuron Lite.
UCCNC v1.2105 Macro Manual
Robertspark
 
Posts: 726
Joined: Sat Sep 03, 2016 4:27 pm
Location: Nr Liverpool, England


Return to Ask a question from support here

Who is online

Users browsing this forum: No registered users and 1 guest