Gecko 540 limit switch set up (sorry for the duplicate)

If you have a question about the software please ask it here.

Gecko 540 limit switch set up (sorry for the duplicate)

Postby Ronm » Fri May 05, 2017 3:25 pm

I have gecko 540 and uccnc100. The Estop switch works, but none of the limit switches come through. I wired the with 2 switches in series for each axis, one side to ground the other to pin10,11, or 12. I manually checked to switches, they're ok. On the uccnc diagnostic page, port 1, I never see the state of pins10-12 change when the switch is toggled. When I power off the gecko, pin10-12 go green. How do I set this up?
Ronm
 
Posts: 3
Joined: Fri May 05, 2017 2:58 pm

Return to Ask a question from support here

Who is online

Users browsing this forum: Bing [Bot] and 5 guests