Rigid Tapping and FRO

If you have a question about the software please ask it here.

Re: Rigid Tapping and FRO

Postby cncdrive » Fri Feb 17, 2017 12:14 am

No, I don't think it resets the FRO to 100%, but the feedrate is controlled by the spindle rotation when G33.1 and not by the programmed feedrate compensated by the FRO like it is with normal motions commands like G0, G1 etc., because the axis follows the spindle rotation when G33.1, so the axis will go with the proportinal speed the spindle rotates, so ofcourse it is not overridable as it would immediately cause a broken tapping tool.
cncdrive
Site Admin
 
Posts: 4695
Joined: Tue Aug 12, 2014 11:17 pm

Return to Ask a question from support here

Who is online

Users browsing this forum: Google [Bot] and 7 guests