forum.cncdrive.com

Posted: **Mon Mar 13, 2023 10:15 am**

Hello,

Im using the UCCNC Software and vectric v carve pro for my laser. Is there any compatible postprocessor to get the right M10 M11 gcodes without changing anything?
Wich postprocessor would you use?

Thanks a lot!

Posted: **Tue Mar 14, 2023 9:51 am**

Now I found one for the UCCNC on the jtech Website. It was for inches and I changed hin to MM.

forum.cncdrive.com

Postprocessor for UCCNC using V carve pro 11.5 for laser

Postprocessor for UCCNC using V carve pro 11.5 for laser

Re: Postprocessor for UCCNC using V carve pro 11.5 for laser