forum.cncdrive.com

Hello,

I got a new PC with Windows 10.
If Im setting it up like in the that manual I get an Error when testing the connection.

Is there an other way to make the Network connection work under Windows 10?

As that screen is telling you its set up wrong. I had zero issues when did mine two weeks ago. Follow the instructions step by step and it works. I needed a cross over cable but it still was connected.

You have to set the network adapter IP address to 10.10.10.10 and not to 10.10.10.11.

I was going to suggest he use the Windows Snipping Tool and post those instead of picture of the screen.

Thank you! It works!