Can I re-use an end-stop pin during probing?
![Post Post](./styles/prosilver/imageset/icon_post_target.gif)
Hi there,
I have a handy z-axis end-stop button right there, above the spindle. Can I assign that pin to the probe as well and use it during probe cycles? Or, will the z-stop trigger during a probe cycle?
Thanks!
I have a handy z-axis end-stop button right there, above the spindle. Can I assign that pin to the probe as well and use it during probe cycles? Or, will the z-stop trigger during a probe cycle?
Thanks!