Page 1 of 1
Restart Huanyang plugin
Posted:
Sun Oct 16, 2022 12:58 pmby George M
I sometimes want to keep my controller running for multiple days, but much of that time is waiting on something but I would like to shut down my spindle.
Is there a way to restart my spindle (using the Huanyang plugin) without restarting UCCNC?
Thanks
Re: Restart Huanyang plugin
Posted:
Tue Oct 18, 2022 2:05 pmby George M
Bump
No one knows if it is possible to restart a plugin while UCCNC is running?
Re: Restart Huanyang plugin
Posted:
Tue Oct 18, 2022 8:08 pmby dezsoe
Plugins are loaded when UCCNC starts up, so you cannot restart just a plugin. (However, the developer of the plugin may write the plugin to be restartable, but as far as I know there were no changes in the last few years in this plugin.)
Re: Restart Huanyang plugin
Posted:
Wed Oct 19, 2022 2:18 pmby George M
Ok, Thanks for the info