forum.cncdrive.com

Posted: **Fri Dec 09, 2016 7:27 am**

Hi Balazs,

would I be correct in assuming all system #vars would initialise to zero at system startup.

Also would it be bad programming practise to assume this, and should I have the Constructor Macro initialise any #vars I use to zero.

Keith

Posted: **Fri Dec 09, 2016 9:06 am**

Hi Keith,

The UCCNC sets all #vars values to zero on startup.

Posted: **Fri Dec 09, 2016 1:08 pm**

Perfect, thanks Balazs.

That's what I was hoping for.

Keith

forum.cncdrive.com

System #vars value at startup

System #vars value at startup

Re: System #vars value at startup

Re: System #vars value at startup