Page 1 of 1

M106 + M107?? removed from v1.2112?

PostPosted: Wed Oct 09, 2019 5:44 pm
by Robertspark
M106 : Turns the spindle PWM on (Parameters P) The range of P is 0 to 255. This macro is used to control the FAN speed in 3D printing
M107 : Turns the spindle PWM off

Has M106 + 107 been removed from uccnc???

Any reason why, thanks?

{I was controlling a probe with it} :lol:

Re: M106 + M107?? removed from v1.2112?

PostPosted: Wed Oct 09, 2019 8:03 pm
by cncdrive
No, we did not remove it.

Re: M106 + M107?? removed from v1.2112?

PostPosted: Thu Oct 10, 2019 1:00 am
by Robertspark
I was updating the macro manual and saw that it was not listed on the screenset help modes or within the manual, thanks I was just checking

Re: M106 + M107?? removed from v1.2112?

PostPosted: Thu Oct 10, 2019 1:32 am
by cncdrive
I have also checked that afterwards I wrote my post and it is really missing from the help page and it is a mistake in the helpscreen.
The macros are still in the UCCNC, we did not remove them and I also verified that they are working. :)