I have A-Axis as a slave to Y-Axis.
Is there any way or workaround so that i can set different "Steps/Unit" Value on the Y-Axis and A-Asis.
When i try to change the value of A-Axis i jumps back to the value of Y-Axis.
The reason is that my slave axis screw seems to have a slight deviation in travel that i want to compensate for.
//Martin.
Slave axis calibration
2 posts
• Page 1 of 1
Slave axis calibration
by MartinSkoog » Tue Feb 05, 2019 2:18 pm
- MartinSkoog
- Posts: 1
- Joined: Tue Feb 05, 2019 2:13 pm
Re: Slave axis calibration
by cncdrive » Tue Feb 05, 2019 2:26 pm
Different step numbers for master and slave axis is not supported.
- cncdrive
- Site Admin
- Posts: 4719
- Joined: Tue Aug 12, 2014 11:17 pm
2 posts
• Page 1 of 1
Return to Ask a question from support here
Who is online
Users browsing this forum: No registered users and 5 guests