I seem to be having a problem with UCCNC freezing randomly, guessing it will be something to do with windows rather than the UCCNC software itself. Running the latest downloadable safe version from the UCCNC website with the latest version of ger21 screenset on a windows 7 64 bit computer. I have done very little to optimise the PC for use with the CNC, it isn't connected to internet & some of the standard maintenance tasks like checking for updates, running virus scans ect are disabled or turned off & the power saving features are turned off so computer never hibernates or shuts down but that is about all I have done.
So what else should I have done to prevent this happening?
The last computer was fully optimised for running mach3 & mach3 was the only software installed on the computer but having switched to a UC400 ETH controller & UCCNC software I thought I didn't need to strip the computer right down for it to work OK