Slave Axis Tuning Independent of master?

If you have a question about the software please ask it here.

Slave Axis Tuning Independent of master?

Postby mende200 » Fri Jul 06, 2018 9:40 pm

Is it possible for me to have the slave axis tuning and backlash values different than the master? Whenever I hit apply or save, it pushes the master values to the slave. I primarily need different backlash values.

I have been looking and cannot find anything, sure it's a simple thing.

thanks,

Brad
mende200
 
Posts: 6
Joined: Fri Jul 06, 2018 9:30 pm

Re: Slave Axis Tuning Independent of master?

Postby cncdrive » Sat Jul 07, 2018 1:37 am

No, it is not possible.
cncdrive
Site Admin
 
Posts: 4695
Joined: Tue Aug 12, 2014 11:17 pm

Re: Slave Axis Tuning Independent of master?

Postby Robertspark » Sat Jul 07, 2018 3:19 am

Can you not reduce the backlash to acceptable levels ?

What sort of a drive mechanism is it (ballscrew, threaded rod, rack+pinion, belt drive?)
Robertspark
 
Posts: 1892
Joined: Sat Sep 03, 2016 4:27 pm

Re: Slave Axis Tuning Independent of master?

Postby Robertspark » Sat Jul 07, 2018 3:26 am

Try not to double post threads on the same or similar topics or becomes a pia to reply and keep track of the question or original poster
(It gets more confusing when you ask the same poster similar questions about their setup in two threads)

I'll reply to this one in the other thread
viewtopic.php?f=4&t=1362
Robertspark
 
Posts: 1892
Joined: Sat Sep 03, 2016 4:27 pm


Return to Ask a question from support here

Who is online

Users browsing this forum: No registered users and 18 guests

cron