i purchased uccnc for my new plasma table last week.I am using a uc300eth. I got it up an running today. All is working except for that when i home my x and the a axis which is slaved to the x axis, the a axis becomes unslaved. I go into config axis and do nothing but save the settings again and all is good..
I don,t know if this is relevant , but i only have one pin for home and limits until i get an extra breakout board installed. I cant seem to get it to home without tripping a limit and having to reset, so i am homing each axis individually. I am hoping the extra pins on my new BOB when it arrives will sort this. Any advice would be gratefully appreciated.
Thanks Sean