Esc key press event from macro.

If you have a question about the software please ask it here.

Esc key press event from macro.

Postby kig23 » Fri May 11, 2018 2:45 pm

I 'm wondering if there is a way to handle esc key press event from macro. Thanks
kig23
 
Posts: 44
Joined: Sat Mar 31, 2018 6:58 am

Re: Esc key press event from macro.

Postby Vmax549 » Fri May 11, 2018 5:30 pm

Considering there is already an {ESC} sequence running in teh UCCNC core it might be tough to build another inside of a macro and it run seperately .

(;-) TP
Vmax549
 
Posts: 915
Joined: Sun Nov 22, 2015 3:25 am
Location: USA

Re: Esc key press event from macro.

Postby cncdrive » Fri May 11, 2018 9:39 pm

No, there is no core function for the ESC key.
The ESC key is by default is attached in the hotkeys to call button 130. which is the stop function.
So pressing ESC calls the stop function of the UCCNC by default (setup in the default profile), but ofcourse that hotkey call could be deleted or exchanged from the hotkeys on the hotkeys page.
cncdrive
Site Admin
 
Posts: 1860
Joined: Tue Aug 12, 2014 11:17 pm

Re: Esc key press event from macro.

Postby kig23 » Sat May 12, 2018 6:04 am

Thanks Balazs for this information.
kig23
 
Posts: 44
Joined: Sat Mar 31, 2018 6:58 am

Re: Esc key press event from macro.

Postby Vmax549 » Sat May 12, 2018 12:43 pm

Cool, Thanks Balazs for the info.

(;-) TP
Vmax549
 
Posts: 915
Joined: Sun Nov 22, 2015 3:25 am
Location: USA


Return to Ask a question from support here

Who is online

Users browsing this forum: naijin and 1 guest