Page 1 of 1

Mach3 errors

PostPosted: Mon Apr 09, 2018 5:51 am
by Tim_DGE
Hi All,

I have begun setting up the UC300ETH-5LPT. I got a parallel breakout board to which I’ll connect the UC300. Now I did all the network settings and there doesn’t seem to be a problem, it pinged the network correctly and everything. I also installed the Mach3 plugin. However, when I start up Mach3, it detects the plugin, I select the UC300, then it gives the first error: (See attached “Error1” jpeg)

After this it asks if I want to replace the firmware. When I select “Yes” it gives the following: (See “Error2” jpeg).

Can you help?

I have not connected any components to the boards yet (motors, switches, etc).

Regards,
Tim

Re: Mach3 errors

PostPosted: Mon Apr 09, 2018 6:48 am
by Tim_DGE
I seem to have solved the problem. The UCx00setup had not properly installed. Once I did that, I redid the network settings, and when opening Mach3, firmware successfully installed.