M125 Px PREVIOUS Px value applied not latest Px value

If you have a question about the software please ask it here.

Re: M125 Px PREVIOUS Px value applied not latest Px value

Postby dammogreen » Sun Feb 18, 2018 6:40 pm

Good , fast work by you, thanks.

I will use the double (or triple) M215 kludge or a delay maybe until it is fixed.
dammogreen
 
Posts: 61
Joined: Thu Jan 11, 2018 10:24 pm

Re: M125 Px PREVIOUS Px value applied not latest Px value

Postby dammogreen » Tue Feb 20, 2018 4:23 am

FYI,

I just tested something.

It has to be two M215 Px in a row like this:
M215 P1
M215 P1 (actual ratios are now applied for pulley 1)
M215 P2 (still on ratio for pulley 1)
M215 P2 (actual ratios are now applied for pulley 2)

--------------------------
a delay does not work, will not cause a pulley ratio change.

M215 P1
M215 P1 (actual ratios are now applied for pulley 1)
M215 P2 (still on ratio for pulley 1)
G4 P1 (1 second in my case, not mSec)
(still on ratio for pulley 1)

maybe some other commands like x movements will cause the type of delay that will work, did not test
dammogreen
 
Posts: 61
Joined: Thu Jan 11, 2018 10:24 pm

Re: M125 Px PREVIOUS Px value applied not latest Px value

Postby cncdrive » Fri Feb 23, 2018 10:05 pm

This was corrected now in test release 1.2103, please test it and let me know if there is still any problems with it.
cncdrive
Site Admin
 
Posts: 4695
Joined: Tue Aug 12, 2014 11:17 pm

Re: M125 Px PREVIOUS Px value applied not latest Px value

Postby dammogreen » Wed Mar 07, 2018 12:13 am

Yes, seems ok now.
G33 pitch distance moves correctly after just one M215 Px
dammogreen
 
Posts: 61
Joined: Thu Jan 11, 2018 10:24 pm

Previous

Return to Ask a question from support here

Who is online

Users browsing this forum: No registered users and 29 guests