Re: Temporary offset of Probing Position for large tool
Posted: Sat Jul 08, 2023 1:53 pm
Yes it is turned on !
UCCNC machine control software support forum
http://forum.cncdrive.com/
dezsoe wrote:Well, my goal was to fully integrate the probe in the screensets, that's why it has no config window but a setup page. This offset was a special request here on this forum (I couldn't find the topic) and I left it in the code, because it is useful. I'll think about creating something to set these settings.
dezsoe wrote:Hmm... Here is how to turn on debug mode and save the results. Please, upload the log: it should not move that way.