forum.cncdrive.com

Hello Every one, im having an small problem using the ATC from stepcraft. i thiks is a Bug from Macro 20206. when i change the current tool using the release button on UCCNC it opens the ATC and keep opening making a Rattling soundon the Switch Box. until i press the button again to close, its not a nromal behaivor.

any suggestion will be highly appreciated.

Best,

Esteban

It would be good to know how that ATC exactly works and then see the macro file.
You can open the macro file with a text editor and could follow through the logic to see if it requires any code change the fix the mentioned issue. (If it can be fixed, I'm not sure as I don't know your ATC in details yet.)