forum.cncdrive.com

Feed overdrive issue when inverse feed G93 is active
If feed overdrive is adjusted, motion controller stuck, all motion completely stop, until cycle start.
Basically I cannot adjust feed on 4x jobs.

Which software version are you using?

I discovered this bug couple years ago. Lastest 17 version issue still exist.
I upload gcode for testing

We will test it soon.
Thank you.

Just tried this in demo mode. Ver 1.2116

Running the supplied code it froze after changing the feed rate override. Not straight away but after a few changes.

This is the error message.
File:/Profiles/Macro_Router/M2845.txt Could not read!

I can find no such macro number in the profile. Perhaps it is an internal macro that we have no access to.

Wondered if changing the override multiple times to quickly has something to do with it.

Any news?