Page 1 of 1
Feed override active also for probing?
Posted:
Tue Sep 03, 2024 2:21 pmby richardk
I realized that when I have set feed override to e.g. 200%, also Z probing feeds (possibly also another probing?) are affected (doubled in this case). I think it is not OK, it is dangerous (can cause damage of probe..)
Re: Feed override active also for probing?
Posted:
Sun Sep 15, 2024 7:18 pmby Carboncnc
Yes I agree... I have the same, so it is intended I guess.
But just as you say, the override should NOT affect probing in my opinion. I dont know how it is in newer versions of UCCNC.
Re: Feed override active also for probing?
Posted:
Sat Sep 28, 2024 7:38 pmby Battwell
it is extremely handy if you want to slow it down for testing though!
Re: Feed override active also for probing?
Posted:
Sun Sep 29, 2024 8:41 pmby cncdrive
I will discuss this with my collegues soon.
Re: Feed override active also for probing?
Posted:
Mon Oct 14, 2024 6:35 amby Carboncnc
Battwell wrote:it is extremely handy if you want to slow it down for testing though!
Perhaps being able to just lower the speed could be doable, that would be nice.