forum.cncdrive.com

I installed UCCNC v1.2113 (new installation) with a UC400ETH. I am able to connect to the machine (using a direct cross-over cable) and jog the axes.

I cannot create a new profile. I take the following steps:

1. I fill in a new profile name (for example, NewProfile).
2. I click the "Create new Profile" button.

Immediately upon clicking the button the profile name is erased, and a message is displayed telling me that a profile could not be created because the profile name is missing.

Hit the "ENTER" key after typing in the profile name.

Gerry,

Thanks. I spent some time reading through some other posts last night after submitting my message and realized that ENTER was mandatory. There's a setting that can be used to eliminate it, but I haven't tried that yet.

I keep forgetting Enter button too