Z Movement after G49 Unpredictable

If you think you've found a bug post it here.

Z Movement after G49 Unpredictable

Postby ADuarte » Sat Mar 27, 2021 2:20 pm

I am running UCCNC Version 1.2111 with AXBBE . If I stop a program partway through the run cycle using Feedhold and then stop, I type G49 on the MDI line,
and then MDI a Z axis move (Z2.00), the machine will move to z2 and then rapid to Z.1. I can repeat the G49, and then Z2 in MDI and the machine will go to Z2 and then rapid to z.1 again. The z.1 looks like it is including the tool height offset because the position with the tool in the spindle looks about .1" above the part.
ADuarte
 
Posts: 6
Joined: Mon May 20, 2019 4:50 pm

Return to Report a bug

Who is online

Users browsing this forum: No registered users and 12 guests

cron