forum.cncdrive.com

Sorry Keith, but this screenset designing took so much time and we were "forced" to release it asap that we did not had time to make that change in the UCR201 plugin, but since the 1.2112 seems to have a few bugs we will make a new release soon anyways, and then the plugin change will be also done in that soon.

Thanks very much Balazs, no problem.

I know this software game must be a never ending story. Bug, new features, new screensets, it never ends

Keith

Yes, we always have ideas, also customers always have ideas, so yes it is a never ending story.

Hi Balazs,

I've just checked v1.2113 and see the stop button still rewinds gcode if pressed more than once.

Fixed in next release maybe ?

beefy wrote:Hi Balazs,

I've just checked v1.2113 and see the stop button still rewinds gcode if pressed more than once.

Fixed in next release maybe ?

Bump.

I'm guessing this was missed again because other posts are being responded to.

It's been over 5 months since I first mentioned about this. Is it a lot of work to fix this.

Keith.

Hi Keith,

Dezsoe should have already fixed this, didn't he?

Doesn't seem to be Balazs.

I'm using the latest development version v1.2113 and I excitedly tried the stop button on the pendant to see it the gcode file would still rewind when I pressed the pendant stop button more than once.

Did it twice and the gcode file rewound both times.

I know you said some time ago that there may be a tick box added to disable the gcode rewind, but there's no such tick box available in the plugin window.

Keith.

No, I didn't fix it. I talked to the other Balázs to fix this and some other things. I'll report if there is anything.

dezsoe wrote:No, I didn't fix it. I talked to the other Balázs to fix this and some other things. I'll report if there is anything.

Hi Dezsoe,

any update on this. I know you guys are always busy but I would have thought this is not a big job to correct.

I bought the pendant after doing a big long plasma cutting job, where lots of tip ups happen, and I was pausing the cut (at the PC) to lift out these tip ups before continuing the cut.

Because the pendant screen goes into sleep mode after some time you have to press the stop button twice. It's easy to press it a 3rd time in a panic situation then your file is rewound.

Would the other Balazs be able to give you some estimate of when he may get around to modifying the program.

Cheers,

Keith.

Hi Keith,

He started to work on it this week. I'll inform you here if there is a new plugin version.