Close file button issue.

If you think you've found a bug post it here.

Close file button issue.

Postby kig23 » Sat Mar 31, 2018 7:19 am

When you open UCCNC and then press the Closefile button without loading a G-code file in the Toolpathviewer you will see the writing "Loading file" and the loading bar for a while, and in the Codeviewer you'll see a red and white writing "Closed". I'm using UCCNC version 1.2047.
kig23
 
Posts: 158
Joined: Sat Mar 31, 2018 6:58 am
Location: Italy

Re: Close file button issue.

Postby dezsoe » Sat Mar 31, 2018 5:44 pm

In short: yes.

In longer: all versions of UCCNC do the same. I think you have a computer slow enough, if you have time to see this and read all text. :) Anytime you close a file this happens. UCCNC loads the file Empty.txt in the Contents folder. (Check Diagnostics tab after Close is pressed.) There's no bug, UCCNC works this way.
dezsoe
 
Posts: 2049
Joined: Sun Mar 12, 2017 4:41 pm
Location: Csörög, Hungary

Re: Close file button issue.

Postby kig23 » Sat Mar 31, 2018 6:00 pm

Thank you.
kig23
 
Posts: 158
Joined: Sat Mar 31, 2018 6:58 am
Location: Italy


Return to Report a bug

Who is online

Users browsing this forum: No registered users and 3 guests