Hi
It’s quite strange.
My cnc pc died I had an urgent job so decided to use an old Windows XP’s machine. Quite a nice pc but old.
Installed and configured UCCNC fine, profile loaded. It looks good. The machine homes and jogs without an issue but!
If you load a job and run it, it stops at the first line. The timer runs and counts up but nothing else. However if you minimise the program then maximise it again the codes runs as normal. I found this by mistake when trying to sort out why it was not running.
It is absolutely repeatable too.
If you stop and rewind the minimise/ maximise thing has to be done again....
Any ideas on how to fix this
Cheers
PeteM