Tool Table View Glitch

If you think you've found a bug post it here.

Re: Tool Table View Glitch

Postby Dan911 » Thu Feb 01, 2018 1:07 am

I can't help but feel this is a baited post but I'll go for it and ask...lol

Doesn't .5 = .50000000000000000000000000000000000000000000000000000000
Dan911
 
Posts: 521
Joined: Mon Oct 31, 2016 1:22 am
Location: USA

Re: Tool Table View Glitch

Postby cncdrive » Thu Feb 01, 2018 8:05 am

The tooltable values strings are not formatted and so 1.2 will be 1.2 and not 1.2000 and 1.23 will be 1.23 and not 1.2300.
The question is if they should be formatted at all?
cncdrive
Site Admin
 
Posts: 2461
Joined: Tue Aug 12, 2014 11:17 pm

Re: Tool Table View Glitch

Postby dezsoe » Thu Feb 01, 2018 8:59 am

IMHO yes, because on the tools screen there are also 4 decimals and in a table it's easier to view. But only the length and diameter columns. The slot# could be smaller.
dezsoe
 
Posts: 639
Joined: Sun Mar 12, 2017 4:41 pm
Location: Csörög, Hungary

Re: Tool Table View Glitch

Postby cncdrive » Fri Feb 23, 2018 4:49 pm

Tooltable is now formatted to show digits as other DROs setup in the UCCNC settings. Version is 1.2103.
cncdrive
Site Admin
 
Posts: 2461
Joined: Tue Aug 12, 2014 11:17 pm


Return to Report a bug

Who is online

Users browsing this forum: No registered users and 2 guests