Hi.
When you enter a positive value in "Softlimit - (Units:)" and click "Save Settings", it automatically writes the same value in "Write offset on homing (Units):".
This does not happen in software version 1.2117.
Bug in 1.2118
2 posts
• Page 1 of 1
Re: Bug in 1.2118
by cncdrive » Wed Apr 16, 2025 9:39 pm
Hi,
Which axis is it and which motion controller are you running?
I quickly tried it with UC100 screenset and it does not happen, so please tell the motion controller you running hte UCCNC with?
Which axis is it and which motion controller are you running?
I quickly tried it with UC100 screenset and it does not happen, so please tell the motion controller you running hte UCCNC with?
- cncdrive
- Site Admin
- Posts: 5148
- Joined: Tue Aug 12, 2014 11:17 pm
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest