Jog multiple axiis

If you think you've found a bug post it here.

Re: Jog multiple axiis

Postby Zed_UCCNC » Sat Jun 27, 2020 9:41 pm

I think that the problem goes away when I disable backlash compansation.
But I need backlash compensation!
Zed_UCCNC
 
Posts: 12
Joined: Wed Jun 24, 2020 1:15 pm

Re: Jog multiple axiis

Postby Zed_UCCNC » Tue Jun 30, 2020 3:05 pm

cncdrive wrote:OK, my collegue Dezsoe will check it out.

WITH BACKLASH ENABLED
In this video look at the DRO's and stepper between 13 and 24 seconds, the function is normal.
https://youtu.be/NvFRs0yB67o
https://youtu.be/NvFRs0yB67o

During the other part of the video, the input at the keyboard is constant direction for 4 steps BUT the stepper direction of rotation alternates, look at the DRO's, the readout is not normal.

I think this makes jogging to an edge unreliable ( with BL enabled)
Zed_UCCNC
 
Posts: 12
Joined: Wed Jun 24, 2020 1:15 pm

Previous

Return to Report a bug

Who is online

Users browsing this forum: No registered users and 2 guests