Firmware Update Error

Forum for Discussing Mach3/4 related issues

Re: Firmware Update Error

Postby thegreatwaldo » Wed May 20, 2020 9:12 pm

Hi Smelton

I'm reffering to the license file that cnc drive send you when you purchase the the uccnc software. I'm not sure but I think you have to pay a bit extra over the cost of the hardware. I got mine on a special offer a while ago, but uccnc is pretty cheap considering how good it is. (it got my cnc machine working in no time at all after idly sitting around in my workshop gathering dust for years because I couldn't figure out the software that came with my machine)
Cheers
Andrew
thegreatwaldo
 
Posts: 174
Joined: Tue Sep 06, 2016 8:28 pm

Re: Firmware Update Error

Postby Smelton » Thu May 21, 2020 9:38 pm

Ok it sounds like I might have to purchase a licence for UCCNC and try that. This still doesn’t help me figure out why I can’t get Mach4 working though, and I’m hoping whatever problem exists doesn’t stop me from using UCCNC.

I will post back with an update soon. Thanks for the help.
Smelton
 
Posts: 6
Joined: Tue May 12, 2020 8:35 pm

Previous

Return to Mach3/4 Discussions

Who is online

Users browsing this forum: No registered users and 2 guests