UC300ETH MPG #2 working on install

[hanica]

Hi I have just upgraded my old uc300usb tho the ethernet version.
Everything still works apart from:

MPG2 is non functional, the monitor is saying the pins are activating (port5 pins 4,5) but its not causing any movement nor is the position readout changing.
I had this issue years ago when I bought one of the first UC300usb's Balzacs sent me updated code, any Ideas?

switch from continuous jog to mpg jog :
located port 5 pins 8 (cont /working) 9 (MPG / not working)

Is there a software update for these issues?

Regards
Tony

[dezsoe]

The problem is that we cannot find out which version of what software do you use. Because you mention MPG2, I think it's Mach3 or Mach4. If yes, then you should ask in the Mach3/Mach4 topic.

[cncdrive]

I forwarded this matter already for testing to my collegue who works with Mach3 plugins, he will check it out asap.
It will take some time though, because he is a bit overloaded now.

[hanica]

3 months later still no reply!!

[cncdrive]

I will ask my collegue about it.

[gregarious2]

Itʻs been a few months but Iʻm still wondering if the UCC300eth can read my front panel MPG using pin 13 and 15 on Port 1 after upgrading to the C94. J It has been one of my favorite features for 12 years using Mach3 and a Soundlogic BOB. I can see the LEDS flicker on the BOB when rotating the knob and in the I/O monitor on the PC. Mach3 is configured to use it. Has anyone added a non pendant MPG under Mach3 and the Ucc300eth???