Page 1 of 1

Re: Cut Circle Wizard

PostPosted: Sat Jan 13, 2018 2:13 am
by Dan911
Nice job Terry! Certainly shows the versatility of UCCNC between macro here and example plugin I posted.

Dan

Re: Cut Circle Wizard

PostPosted: Sat Jan 13, 2018 2:27 am
by bennyhines70
circle wizard.jpg
Terry could you use something like this drawing i made with your macro..?

Re: Cut Circle Wizard

PostPosted: Sat Jan 13, 2018 1:32 pm
by Dan911
Vmax549 wrote:HIYA DAN, You have not seen anything yet. You can take a clear picture of an OLD control say a Fadal. Load teh picture as a background and input teh data fields over the picture and have a Modern control that LOOKS and feels like teh OLD control GUI.

Want a NEW controller that looks like an old Fanuc ?? NOT a problem (;-)

(;-) TP


cool...Did something similar with background image but with buttons.