Page 6 of 7

Re: Put my name on the list for lathe users

PostPosted: Tue May 07, 2019 3:37 am
by asuratman
things like these fillet, boring, taper, arc, groove, facing all work well, maybe only threading not working properly.

Re: Put my name on the list for lathe users

PostPosted: Tue May 07, 2019 11:19 am
by ger21
There is no lathe mode.

Re: Put my name on the list for lathe users

PostPosted: Tue May 07, 2019 11:19 am
by cncdrive
Threading works perfectly with the UCCNC if this was the question?!

Re: Put my name on the list for lathe users

PostPosted: Wed May 08, 2019 3:25 am
by asuratman
Thanks for reply, I will try it when I have AXBB-E ready.

Re: Put my name on the list for lathe users

PostPosted: Fri Feb 21, 2020 2:15 pm
by asuratman
Is there any plan for uccnc lathe in the near future ?

Re: Put my name on the list for lathe users

PostPosted: Sat Apr 16, 2022 10:58 am
by rodrigjup@gmail.com
Count me in !

Re: Put my name on the list for lathe users

PostPosted: Wed Jul 20, 2022 10:57 am
by BKG
Me to

Re: Put my name on the list for lathe users

PostPosted: Fri Dec 30, 2022 4:21 am
by spillage
Count me in as a prospective UCCNC Turn user.
I have a lath project somewhere in my future, and would prefer to stick with UCCNC than look at others like Acorn or Masso.

Re: Put my name on the list for lathe users

PostPosted: Fri Dec 30, 2022 12:06 pm
by cncdrive
UCCNC lathe version is basically finished with very good basically full featured lathe support with lathe screenset, lathe toolpath view, G95, G7/G8 and G96 support, we also added X tool offset to support lathes.
The next release will contain all these and we will continue working hard in January to release it asap.

Re: Put my name on the list for lathe users

PostPosted: Sat Dec 31, 2022 6:54 pm
by markcadcam
I'm looking forward to checking it out!