G41/G42 discussion.

Post anything you want to discuss with others about the software.

Re: G41/G42 discussion.

Postby sigraph » Wed Apr 18, 2018 1:18 am

I would like to be selected to try out the "new" cutter comp that is available.
I started running CNC machines in about 1986. When there were no cad programs available (unless you worked for NASA or GM).
Cutter comp back then was very useful for programming a tool path to follow outside or inside a given path and not having to do the math to offset half the tool radius.
Just program the path and use G41 to climb around the programmed path to cut a pocket.
Usually it was "G41 D17 etc..." and I could measure the pocket and make an offset in the "D17 register" and cut it a little bigger to make an easy finish cut while using the same program.
Posts: 1
Joined: Tue Aug 29, 2017 2:25 pm

Re: G41/G42 discussion.

Postby ger21 » Wed Apr 18, 2018 10:34 am

Download the latest test version and try it.
UCCNC 2017 Screenset - http://www.thecncwoodworker.com/2017.html
Posts: 1143
Joined: Sat Sep 03, 2016 2:17 am


Return to General discussion about the UCCNC software

Who is online

Users browsing this forum: No registered users and 3 guests