Cutter Comp

Post anything you want to discuss with others about the software.

Cutter Comp

Postby Zadig » Tue Oct 31, 2017 2:10 pm

Would it be possible to have a date for the rollout of cutter comp, an approximation would be fine. I currently have a UC300ETH board and the control software sat on a shelf, where it has been for a few months, unusable until cutter comp is made available. I fully accept that I made a mistake when researching these items prior to purchasing them, but I would like to move forward from Mach 3 and some idea of whether to sell these purchases and cut my losses or hold out for what looks like a good product, would be helpful.
Zadig
 
Posts: 46
Joined: Tue Aug 29, 2017 9:17 pm
Location: UK

Return to General discussion about the UCCNC software

Who is online

Users browsing this forum: No registered users and 15 guests