Zero point setting

Post anything you want to discuss with others about the software.

Zero point setting

Postby jjl » Sun Jun 04, 2017 10:26 am

Hi All.

First of all, I'm new to UCCNC and Fusion360, so maybe this is a stupid question, but here it goes:

I have made this simple model (see attached pic) in Fusion, made a 2D contour, with zero point (WCS) at the left side corner, generated the toolpass using the Generic UCCNC Post Processor.
Fusion.gif
Fusion


Then I load the .nc file in to UCCNC, but now the zero point is in the middle of the model !!! (See attached pic)
UCCNC.GIF
UCCNC


How do I correct this, so I have the zero point at the same place in both Fusion and UCCNC ??
Thanks in advance
Best regards
Jens J. Larsen
Vodskov
Denmark
jjl
 
Posts: 5
Joined: Sat Jun 03, 2017 7:03 pm

Re: Zero point setting

Postby jjl » Sun Jun 04, 2017 8:46 pm

Problem solved.

Origin have to be set in the Fusion Cam Setup folder not in the Contour folder

/JJ
jjl
 
Posts: 5
Joined: Sat Jun 03, 2017 7:03 pm


Return to General discussion about the UCCNC software

Who is online

Users browsing this forum: Bing [Bot] and 17 guests

cron